Alarm Lock DL1200 Manuál s instrukcemi stáhnout pdf (Strana 3)

Install Cylinder

1. Install Cylinder if not already installed at the factory.

Screws A & B (see Fig. 1) are correctly set at factory. If

it is difficult to screw in the cylinder, loosen the two

screws near the actuator (A) one turn. If you find the cyl-

inder is still difficult to screw in, then loosen the other

screws (B) one turn. Do not loosen the screws all the

way or it may be difficult to replace them properly!

Note: The trim is manufactured to use a 1-1/8" or 1¼"

Alarm Lock mortise cylinder with a HW-1302 cam. If the

cylinder that will be used is longer than 1¼", a collar

must be utilized. Please see the collar information on

the previous page.

1a. Insert key half-way into the cylinder, then screw it in.

See Fig. 1a. If cylinder will

not seat flush, the cylinder

back stop screw may re-

quire loosening. Cylinders

that are longer than 1¼"

will require a collar, which

will stick out from the sur-

face when correctly in-

stalled. Please see the

cylinder information on the

previous page.

1b. After the cylinder is screwed in all the way, center

the keyway toward

the bottom (see Fig.

1b). If an interchange-

able core cylinder is

utilized, then center the

interface toward the

bottom. Tighten the

screws that were loos-

ened in step 1.

1c. Remove the key. Use a 1/16" hex wrench to screw

the cylinder back

stop screw in fully.

(See Fig. 1c) The

key should now

only rotate counter-

clockwise.

NOTE: To remove

cylinder, reverse

steps 1a-1c.

Setting the Door "Hand"

2. With the key always on the outside, the door hand is

generally determined by the location of the hinges--

hinges are either inside or outside. See Fig. 2.

2a. Setting Hand of Interface Cylinder/Adapter

See Fig. 2a to determine if changing the retractor arm is

necessary; if so, continue with the steps below.

2b. Remove the retaining ring with

a small tool such as screw-

driver or small needle-nose

pliers (see Fig. 2b).

Pull out the pin and the spring.

2c. Flip over the retractor arm as

shown in Fig. 2c.

2d. There are two types of

springs; an RH spring in-

stalled at the factory, and an

LH spring (supplied). Select

the LH spring (see Fig. 2d).

Fig. 1a: Insert key 1/2 way

into cylinder and screw in

RIGHT HAND LEFT HAND

STANDARD

REVERSE RHR

LHR

Fig. 2: Cross Section Top View -- Door Hand

(Hinges)

(Keys)

STANDARD

REVERSE

Fig. 2a: LH and RH orientation for Interface cylinder, retractor arm, spring

and door latch. The RH orientation is shipped from the factory.

LH RH (factory installed)

Fig. 2b: Remove retaining

ring.

Fig. 2c: The retractor arm

placed for LH operation.

etra

tor

arm

Fig. 1b: Center keyway toward bottom

Fig. 1c: Use 1/16" hex wrench to screw in

the cylinder back stop screw

Fig. 1: Install Cylinder if not already installed at the factory

Cylinder back stop

screw

1 2 3 4 5 6 7 8

Komentáře k této Příručce

Žádné komentáře

Alarm Lock DL1200 Manuál s instrukcemi Strana 3

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Alarm Lock DL1200