Alarm Lock DL1200 Manuál s instrukcemi stáhnout pdf (Strana 4)

2e. Pre-load the spring by placing the "anchor" end over the

"arm". See Fig. 2e below.

2f. Insert the pin through the

top of the new LH spring.

2g. Insert the pin/spring

through the retractor arm

hole while simultaneously

inserting the "anchor" end

of the spring into the

small hole in the cylinder/

adapter. See Fig. 2g.

Pull the arm and hook its end onto the retractor arm.

2h. Re-install the retaining ring

displayed in Fig. 2h.

Finished configuration

shown at left (Fig. 2i).

Install the Lever

3. Install the lever with

proper orientation for the

lock/door hand used.

Tighten the set screw us-

ing a 1/8" hex wrench (see

Fig. 3).

IMPORTANT! The top of

the set screw must be at

(or below) lever surface. If

not, check to ensure the

lever is fully pushed to-

ward the trim.

3a. Install the Adams Rite

product as indicated by the

Adams Rite

door prep guide-

lines and instructions.

• If a new installation, the

face place must NOT be

installed at this time.

• If a retrofit installation,

remove the face plate.

Prepare the Door For

"Through-Bolting"

4. Place template (WI1459) as

shown. Important: Place the

template on top of existing cyl-

inder hole and parallel to the

door edge.

4a. Drill completely through the door for through-bolting

the four mounting holes and battery cover access

bolt hole.

• IMPORTANT!--Drill the holes STRAIGHT

THROUGH the door, or the through-bolts will not

fit in the lock! THIS IS ESSENTIAL! Drill slowly

and STRAIGHT through the door.

• Reposition the template as often as needed until it

is placed correctly.

Insert the Interface Cylinder

5. Loosen the set screw, then remove the outside cylin-

der (if present--See Fig. 5).

Fig. 3: Tighten lever set screw

with 1/8" hex wrench

Fig. 5: Loosen set screw before removing the

old interface cylinder (if present)

Old interface

cylinder

Set screw

Fig. 4: Template (WI1459)

through-bolt holes (circled)

LH RH (factory installed)

Fig. 2d: The RH spring is installed at the factory; the LH spring is supplied.

"anchor"

"arm" "arm"

"anchor"

Fig. 2h: Re-install retaining ring.

Fig. 2i: Ready for LH operation.

Fig. 2f: Insert pin into top of spring.

Fig. 2g: Insert pin and spring; pull arm and clip on hook cam lever.

Insert "anchor" end

into this hole.

Fig. 2e: Pre-load the spring (LH shown) before installing.

"arm"

"anchor"

placed behind

"arm"

1 2 3 4 5 6 7 8

Komentáře k této Příručce

Žádné komentáře

Alarm Lock DL1200 Manuál s instrukcemi Strana 4

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Alarm Lock DL1200