Alarm Lock DL1200 Manuál s instrukcemi stáhnout pdf (Strana 6)

screws before final tightening. Do not over-tighten.

6b. Cover door plates with decorative plate covers by slid-

ing them from top to bottom on door plates.

Connect Batteries

7. Loosen the #8-32 Phillips pan head screw located on

the rear side of the base plate at the bottom of the lock

(see Fig. 7). Turn counter-clockwise until the battery

cover slides off the housing. Do not remove the screw

completely.

7a. Plug in the battery connector and insert the battery

pack into the battery compartment. Neatly push all wir-

ing inside the compartment. Holding battery in place,

slide cover back on. Secure the battery cover by tight-

ening the #8-32 Phillips pan head screw located on the

rear side of the base plate (access this screw from the

7/16" thru-hole drilled in the door). Do not over tighten

the screw.

8. FOR NEW INSTALLATIONS: Refer to programming

instructions (OI310, OI311 or OI312) for specific in-

structions for "First Time Startup" and "Change Fac-

tory Master Code" before connecting the battery.

The lock must be powered up correctly (and have its

factory Master Code changed) or erratic lock behavior

can result.

Test operation: See next page.

Fig. 6a: Secure lock to door -- loosely at first

Door

Thru-Holes

Door Plate

Fig. 6b: Slide down to install decorative plate covers

Fig. 7: The Phillips screw on the rear side locks or unlocks

the battery cover. Do not remove screw.

Fig. 7a: Install the battery pack: Push all wires inside the battery

compartment and slide plate back on.

1 2 3 4 5 6 7 8

Žádné komentáře

Alarm Lock DL1200 Manuál s instrukcemi Strana 6