
5
5a. Push in latch and hold latch in all the way.
5b. While holding in the latch, carefully insert the interface
cylinder assembly into the cylinder hole. The hook must
be in front of the latch retractor and pass through the
notch in the lock case (see Fig. 5b).
5c. The interface cylinder must be centered and posi-
tioned flush with (or slightly below) the surface of the door
(see Fig. 5c).
5d. With the interface cylinder HELD SECURELY in its
correct position, tighten the set screw, securing the
interface cylinder to the lock (see Fig. 5d).
Important! If the interface cylinder is not parallel to the
door after tightening the set screw, then you must verify
that the original Adams Rite
®
lock body was originally in-
stalled correctly (installed square to the door). Failure to
ensure the interface cylinder is installed correctly could
cause lock binding or improper operation of the lock
mechanism.
5e. Install the latch face plate.
Install Lock
6. Install the DL lock onto the door by aligning the two
posts on the front of the interface cylinder with the two
corresponding holes in the back of the DL lock. Lift the
tailpiece slightly to ensure the tailpiece enters the slot of
the interface cylinder.
6a. Secure the DL lock to the door with four through-door
mounting screws and two door plates. Place a door plate
on top of a pair of mounting holes and loosely secure
lock from the inside of the door. Snug all four mounting
Fig. 5c: Position the interface cylinder
Fig. 5d: Tighten the interface cylinder set screw
Fig. 5e: Install the latch face plate
Fig. 6: Install lock onto the door
Fig. 5a: Push latch in and hold
Push in
latch during
interface
cylinder
installation
Interface cylinder
Fig. 5b: While holding latch in, place hook in front of
the latch retractor and through the notch
Notch
Hook
Komentáře k této Příručce